If no ARP entry exists, an ARP broadcast is sent out, and the table is updated with the response. My question why the extender is doing this and how can i setup the extender to NOT do whatever it is doing to the first 3 OCTETs of MAc addresses. Your switch should have a MAC/CAM Table as a layer of two devices, whereas The ARP address table is used to map MAC Addresses to IP addresses. behind the extender or before the extender. Same devices connected to switch and UNIFI AP1 on the Ground Floor shows the correct and ACTIVE connection in DHCP.ĭue to this, devices gets 2 different IPs which works one at a time of course depending on where the mobile device connects to UNIFI AP1 or UNIFI AP2. (all wired through unmanaged switch)ĭevices have no issue getting Internet or communicating to each otherĪll Devices connected to RE650 seems to be showing same first three OCTET of there Mac Adresses Only last three OCTET match the real MAC address.ĭevice1 has C0:EE:FB:25:A0:8Dconnected to UNIFI AP2 and it gets DA:0D:17:25:80:AD (wireless connection)ĭevice2 has 50:E5:49:3B:05:E8 connected to switch which is connected to RE650 and it gets DA:0D:17:3B:05:E8 (wired Connection)
when viewing the list of connected devices, on the routers web page or Tether app. All devices connected to the range extender, appear using the range extenders MAC address.
SHOW MAC ADDRESS OF CONNECTED DEVICE HOW TO
I have an Archer C1200 and a TL-WA830RE range extender. find mac address of device on network show mac address of device in cmd what is mac address of a device how to find device mac address how to check device using mac address how to find device model by mac address look up device using mac address how to check mac address on android get mac address of android phone access a device by mac.
SHOW MAC ADDRESS OF CONNECTED DEVICE PC
Ground Floor: Router - > SERVER2016 (DHCP, DNS and Unifi Controller ) -> UNIFI AP1 Ģnd Floor : RE650 (Extender mode) īroadcast on RE650 is switched OFF both 2.4Ghz and 5 Ghz.Įthernet Cable from RE650 connects to unmannaged switch which than provides connection to UNIFI AP2, Home PC and a HP printer. I have a similar issue, which I think its in fact a problem. I am having a strange issue with MAC addresses which are connected to extender.įirst thing first.